Operation Manual

55
SIKP 2000 B2
GB
Troubleshooting
PROBLEM POSSIBLE CAUSE
POSSIBLE SOLU-
TIONS
The appliance does not
function. The control lamp
“Power 4 does not glow.
The plug 2 is not connected.
Connect the appliance to a
mains power socket.
The appliance is damaged.
In this case, contact Custo-
mer Services.
The appliance does not
start the cooking process.
There is no cookware on the
cooking area 1.
Place suitable cookware
on the cooking area 1.
The cookware is not suitable
for induction cooking areas.
Use suitable cookware
(see chapter "Suitable
Cookware")
Shown in the display 8
is E01.
The appliance is not being
supplied with enough voltage
(< 160 V)..
Check and ensure that the
appliance is connected to
a properly installed mains
power socket with
220 - 240 V
~
, 50 Hz.
Shown in the display 8
is E02.
The appliance is being sup-
plied with too much voltage
(> 270 V).
Check and ensure that the
appliance is connected to
a properly installed mains
power socket with
220 - 240 V
~
, 50 Hz.
Shown in the display 8
is E03.
There is a short circuit inside
the appliance!
Immediately disconnect
the plug 2 from the mains
power socket and contact
the Customer Services
department!
Shown in the display 8
is E05.
The appliance is too hot (in
power levels mode)!
Disconnect the plug 2
from the mains power
socket and wait until the
appliance has cooled
down.
Shown in the display 8
is E06.
The temperature sensor under-
neath the cooking area 1 is
defective or there is a short
circuit..
Disconnect the plug 2
from the mains power
socket and contact the Cus-
tomer Services department.
Shown in the display 8
is E07.
The appliance is too hot
(in Temperature-Mode)!
Disconnect the plug 2
from the mains power
socket and wait until the
appliance has cooled
down.
IB_74434_SIKP2000B2_LB2.indb Abs2:55IB_74434_SIKP2000B2_LB2.indb Abs2:55 10.05.12 14:0010.05.12 14:00