Quick Start Guide

NOTE

► Carefully read the safety guidelines in the operating instructions before

using the appliance for the ﬁrst time!

Preparation

1) Take all the parts out of the box and remove the packaging material and any protective wrapping or

stickers.

2) Clean all components as described in the section "Cleaning and Care".

3) Place the appliance on a clean and level surface.

4) Insert the power plug into the socket.

Working with the kneading hook, beater and whisk

1) Push the release lever  upwards and move the swivelling arm  to the highest position.

2) Insert the mixing bowl  so that the locking mechanisms on the mixing bowl  ﬁt into the recess in

the base . Rotate the mixing bowl  clockwise (cf. symbols

and

on the base ) until it is

locked and stable.

3) Depending on type of application, mount either the kneading hook , whisk - or beater 3 onto

the drive shaft .

4) Add the ingredients you wish to process to the mixing bowl .

5) Push the release lever  upwards and push the swivelling arm  into its working position with the

mounted inset facing downwards.

6) Push the lid  onto the mixing bowl .

7) If desired, mount the ﬁlling nose  to the lid .

Quick guide

short_IB_113373_74_GB.indd 1 29.06.15 16:32

DIN A5 148 mm x 210 mm

PAGE 1
DIN A5 148 mm x 210 mm Quick guide ► NOTE Carefully read the safety guidelines in the operating instructions before using the appliance for the ﬁrst time! Preparation 1) Take all the parts out of the box and remove the packaging material and any protective wrapping or stickers. 2) Clean all components as described in the section "Cleaning and Care". 3) Place the appliance on a clean and level surface. 4) Insert the power plug into the socket.
PAGE 2
DIN A5 148 mm x 210 mm Working with the blender 1) Push the release lever upwards and push the swivelling arm down into its working position. 2) Pull oﬀ the drive unit lid 1. 3) Place the blender 0 onto the blender drive unit + so that the locking mechanisms on the bottom of the blender 0 ﬁt into the recesses in the blender drive unit +. The arrow on the blender 0 must point symbol on the appliance. Rotate the blender 0 clockwise as far as it will go.