Technical data

- 4 -
Warnings about interaction with
batteries
The appliance uses batteries for memory
storage. When handling batteries,
please observe the following:
• If you do not intend to use the appliance
for an extended period, remove the
batteries.
• Regularly check the condition of the bat-
teries. Leaking batteries can cause dam-
age to the appliance.
• Should the batteries leak, put on a pair
of protective gloves and clean the bat-
tery compartment and terminals with
a dry cloth.
Caution!
Never subject the batteries to excessive heat
(i.e. bright sunlight, re, etc.).
Attention!
There is a risk of explosion if the batteries are
improperly replaced. Only replace with the
same or equivalent types.
Notice regarding separation
from mains-power
The
button on this appliance does not
completely disconnect it from the mains
power network. Additionally, the appli-
ance consumes power when in standby-
mode. To completely separate the appli-
ance from mains power, the plug MUST
be removed from the wall socket.
Notice regarding electrical
power surges (EFT / electrical
fast transient) and electrostatic
discharges:
In a case of malfunction due to an elec-
trical fast transient (power surge) and/
or electrostatic discharge, the appliance
must be returned to default settings in
order to re-establish normal operation.
This could mean that it must be discon-
nected from the power supply and then
reconnected. The batteries (if present)
must be removed and then reinserted.
Notice
No liability/warranty claims will be con-
sidered for damage to the appliance
caused by the eects of moisture, water
penetration, overheating or due to un-
authorised modications!
Theappliancecomponents
q VOL— - Volume decrease
w
VOL + - Volume increase
e
MODE/LOCK - Recalls the adjustable
parameters/Button lock
r
Loudspeaker
t Projektor - projects the time onto
a wall
y
SNOOZE/ - Snooze button,/
DIMMER Brightness switch
u
BAND - Switches the radio wave-
band
i
DOWN  - Selector button down-
wards
o
UP  - Selector button up-
wards
a
PROJECTION - Time projection on/o
switch
s
PRESET/ALARM + - Radio station/alarm
memory upwards/
d
PRESET/ALARM – - Radio station/alarm
memory downwards
f
PAGE/AL.SET - switches the memory
sides/calls up the
alarm function
g
Display - Indicator
h A.M.S. MEMORY - Autom. radio station
save
j
SLEEP - Controls the switch-o
timer
k
NAP/USER - User switching, Timer
function
l - On/O switch for
radio functions
BDA_SPU 900 A1 - DT-67087_6_en.indd 4 19.07.2011 17:45:27