Operation Manual

SilverCrest SPWS 180 A1
8 - English
To obtain comparable measurement results, you should always weigh yourself
if possible at the same time of day (preferably in the morning). Always weigh
yourself if possible under the same conditions: on an empty stomach, after
having gone to the toilet and naked.
Please note that values for the stone unit of weight are not represented as
decimal values. The display is divided into two segments by a colon. Only
whole numbers are displayed in the "st" unit of weight to the left of the colon.
The remaining weight is displayed in the "lb" unit of weight to the right of the
colon.
Example: The display indicates "6: 8st". This corresponds to 6st and 8lb.
7.2. Auto Power Off
The bathroom scales have an automatic switch-off function (Auto Power Off function). After
displaying the measurement result, the bathroom scales switch off automatically.
7.3. Replacing the battery
Replace the battery when it is empty. To replace the lithium battery
CR2032, open the cover of the battery compartment (4) at the rear
of the bathroom scales by slipping your finger into the slot on the side
of the battery compartment (4). Now remove the cover of the battery
compartment (4).
To remove the battery, push it down a bit (see the direction of the
arrow in the illustration). You can then remove the battery from the
holder.
Then insert a new lithium battery CR2032. Pay attention to the
polarity when inserting the battery. This is indicated in the battery
compartment (4), and the + symbol on the lithium battery CR2032
must be visible, as shown in the adjoining illustration.
Then replace the cover on the battery compartment (4). The
bathroom scales are now ready to use.