Operation Manual

SilverCrest SPWS 180 A1
English - 9
8. Troubleshooting
8.1. Nothing is indicated on the LCD display.
 The lithium battery CR2032 is empty. Replace the lithium battery CR2032 with another of the
same type. Please note the instructions in the section "Replacing the battery".
 The lithium battery CR2032 is inserted incorrectly. Please note the instructions in the section
"Replacing the battery".
8.2. "Lo" is indicated on the LCD display and the scales switch off.
 The lithium battery CR2032 is almost empty. Replace the lithium battery CR2032 with
another of the same type. Please note the instructions in the section "Replacing the battery".
8.3. "USEL" is indicated on the LCD display and the scales switch
off.
 An error has occurred and the bathroom scales cannot measure your weight. In this case,
step off the tread (2) of the bathroom scales and step on it again. The weight measurement
starts again.
8.4. "Err" is indicated on the LCD display.
 Your weight exceeds the maximum load capacity of 180kg / 396lb. You should step off the
tread (2) of the bathroom scales immediately to avoid damaging the scales.
9. Maintenance / cleaning
It is necessary to service the bathroom scales if they have been damaged in any way, for example,
if the housing is damaged, if liquid or objects have penetrated the bathroom scales or if they have
been exposed to rain or moisture. Servicing is also required if the device is not working properly or
has been dropped. If smoke is produced, or there are any unusual sounds or smells, remove the
battery immediately from the bathroom scales. In these cases, the bathroom scales should not be
used until they have been inspected by authorised service personnel. Only have qualified personnel
carry out the servicing on the device. Never open the housing of the bathroom scales. Only use a
clean and slightly damp lint-free cloth for cleaning and never use any corrosive liquids.