Operation Manual

English SilverCrest USB 2.0 Video Grabber VG 2010
10
 Connect the audio output of your source to the Video Grabber. Use the
Audio adapter cable (4) with the red and white RCA plug.
 Plug the Video Grabber's USB connector into a free USB 2.0 port, ensuring
your PC is switched on. Use the enclosed extension cable (6) if necessary
to extend the reach of the cable. If possible, ensure that the Video Grabber
is directly connected to your PC (not via a USB Hub). Only use the device
with a USB 2.0 port.
 The operating system will automatically detect the Video Grabber. Follow
the instructions on the screen.
 Use the enclosed software to record from your source. The software
provides detailed usage instructions in electronic format. Start the relevant
program.
Audio adapter cable
Using the audio adapter cable (number 4, stereo RCA cable to 3.5mm jack
plug) you can also connect your audio source directly to your PC and so the
device is used as an audio grabber.
Then proceed as follows:
 Connect the audio source directly to the audio input on your soundcard.
Use the audio adapter cable (4).
 Start the 'Cyberlink PowerDirector' program and click on the microphone
symbol.
 Click on the option 'Settings'.
 Choose your soundcard as the 'Audio device'.
 Finally choose the recording source for your soundcard.
For information on setting recording source and recording level
options please consult your computer's documentation.