Rugged Robot A Bluetooth enabled programmable floor robot designed to be used outdoors. User Guide www.tts-group.co.
Important Information ¥ Please retain the information in this User Guide for future reference. ¥ Please read all instructions fully before using. ¥ To clean, wipe the surface with a clean damp cloth. ¥ Do not allow the product to come into contact with water or any other liquids. ¥ Keep the product away from direct sunlight and heat. ¥ In the event of a static discharge, The Robot may malfunction. In this case, please switch it off and then back on again to reset it. Pack Contents ¥ Rugged Robot.
Rugged Robot Programming Rugged Robot Rugged Robot has been designed as an outdoor floor robot. ¥ After initial switch-on, the eyes will light orange and the rear lights will light red, these will remain on until the Robot is turned off. ¥ If the Robot is not used for 5 minutes it will enter low power mode and turn off all lights. Press any button to wake the Robot up. ¥ The sequence memory is cleared on start-up, pressing at this point will simply cause a sound to be played and no motion to occur.
o Mode 3 - Button will flash and Robot will not pause between each sequence when travelling in a straight line, and additionally the turns will be faster for better performance on uneven surfaces. ¥ There is a light sensor which will automatically activate the headlights when the Robot enters a darker environment. Status LED's ¥ There are 6 segments within the ring around the command buttons, during each step these will light green to indicate the command being carried out.
Rugged Robot iOS: ◦ iOS 8.0 Minimum ◦ iOS 9.0 ◦ iOS 10.0 ◦ iOS 11.0 ◦ iOS 12.0 Latest Pairing ¥ Turn your Rugged Robot on to make it discoverable with your device. ¥ Locate the Bluetooth settings on your device. ¥ Switch Bluetooth on and search for nearby devices. ¥ The Rugged Robot will appear on the list of devices. ¥ Select the Rugged Robot on the list to pair with. ¥ Once paired it can be controlled from the app. Battery Precautions ¥ ¥ ¥ ¥ ¥ Rugged Robot is fitted with a 3.
Warning: ¥ Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: ¥ This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Rugged Robot Specification Forward/Backward movement Approx. 20cm Left/Right turn Approx. 45 degree turns Obstacle Sensor Approx. 20cm Battery 3.7V 850mAh Lithium polymer Battery Life approx. 1-2 hours in normal use (depends mainly on amount of movement) Frequency Band range 2.400-2.483GHz Maximum Radio-Frequency power <10mW Speed of movement: 1 x speed = Approx. 0.15m/s 2 x speed = Approx. 0.
Warranty & Support This product is provided with a one-year warranty for problems found during normal usage. Mistreating the Rugged Robot, using the incorrect supply voltage, or opening the unit will invalidate this warranty. Technical Support Please visit www.tts-group.co.uk for the latest product information. Email feedback@tts-group.co.uk for technical support. TTS Group Ltd. Park Lane Business Park Kirkby-in-Ashfield Nottinghamshire NG17 9GU, UK.
