Warranty

SILVERMINE STONE WARRANTY
Silvermine Stone Operating Co LLC (“Silvermine”) products (flats, corners, pillar stone, sills, caps
and accessories each a “Product” and together “Products”) have a limited lifetime warranty from
the date of purchase from Silvermine or one of Silvermine’s authorized dealers, distributors or
contractors (each an “Authorized Representative”) when installed in conformance to local building
codes and manufacturer’s instructions (including use of Silvermine recommended fasteners). This
warranty is limited to the original purchaser and may not be transferred to any subsequent owner.
LIFETIME LIMITED WARRANTY
Subject to the terms, conditions and limitations detailed, Silvermine Stone warrants that its
manufactured Product(s) substantially exhibit the Product(s) qualities and attributes as found at
www.silverminestone.com.
THE SILVERMINE STONE WARRANTY DOES NOT COVER:
Silvermine Stone does not cover any damage to our Product(s) for any causes that are not expressly
covered in this Warranty. The Warranty does not cover any issues associated with conditions or
handling beyond our control that relate to non-defective material. Some representative examples of
issues not covered under the Silvermine Warranty are detailed below:
Building Settlement or Wall Movement - Any damage to our Product(s) resulting from
changes in building structure or the removal and reinstallation of partially or fully installed
Product(s) on the same or a different structure.
Improper Installation or Use of Product(s) - Failure to install Product(s) in conformance
with local building codes, manufacturer’s instructions, the use of unapproved accessories
such as fasteners not provided by Silvermine or its Authorized Representatives and / or the
use of non-breathable sealers. Hearth pieces (flat caps) and all other Silvermine Product(s)
are not warranted for use on the ground or as a surface to foot or vehicular traffic.
Attempted Enhancements or Modifications to Product(s) Beyond the Product’s
Specifications - Painting over colored products, contact with chemicals, staining, varnishing,
sealing with non-breathable sealer or any coating over the manufacturer’s finish, power

Summary of content (3 pages)