SFX Series SX700-PT The standard SFX power supply benchmark Support standard SFX form factor Silent running 92mm FDB fan with 18 dBA minimum All Japanese capacitors High efficiency with 80 PLUS Platinum certification Class-leading single +12V rail Strict ±3% voltage regulation and low ripple & noise 100% modular cables All cable with flexible flat arrays
SPECIFICATION SFX Form Factor SST-SX700-PT 700W Switching Power Supply With Active PFC 80Plus Platinum 1. General 1.1 Scope This specification defines the performance characteristics of a single phase 700 watts, 5 output power supply. This specification also defines worldwide safety and electromagnetic compatibility requirements for the power supply which is intended for use in computer products. 2. Input Characteristics 2.
2.3 Max. Input AC Current Max. Input Current Measuring Range 10.0A 90 - 264Vrms 2.4 Inrush Current The power supply must meet inrush requirements for any rated AC voltage, during turn on at any phase of AC voltage, during a single cycle AC dropout condition, during repetitive ON/OFF cycling of AC, and over the specified temperature range. The peak inrush current shall be less than the ratings of its critical components (including input fuse, bulk rectifiers, and surge limiting device). 2.
3.2 Remote On/Off Controlled mode The PSON# signal is required to remotely turn on/off the power supply, PSON# is an active low signal that turns on the output power rails. When this is not pulled low by the system, or left open, the outputs (except the +5VSB) turn off. This signal is pulled to a standby voltage by a pull-up resistor internal to the power supply. TTL level "H" 2.0 V - 5.25 V "L" 0.0 V – 1.0 V 3.
3.9 Capacitive Load The power supply should be able to power up and operate normally with the following capacitances simultaneously present on the DC outputs. Output Capacitive load (uF) +5V 10,000 +12V 10,000 +3.3V 10,000 -12V 350 +5Vsb 10,000 4. Protection 4.1 Input Protection In primary circuit of the power supply , a protected fuse is inserted. Only internal fault of the power supply will cause the fuse blown.
4. 2. 5 Over-Current Protection Current protection should be designed to limit the current to operate within safe operating conditions.Over current protection schemes where only the voltage output that experiences the over current event is shut off may be adequate to maintain safe operation of the power supply and the system; however, damage to the motherboard or other system components may occur. The recommended over current protection scheme is for the power supply to latch into the shutdown state.
7. Conducted EMI 8. Product Safety 8.1 Safety Requirement 8.2 Leakage Current The AC leakage current is less than 3.5mA when the power supply connects to 253Vac/50Hz. 8.3 Insulation Resistance The insulation resistance should be not less than 30M ohm after applying of 500VDC for 1 minute. 8.4 Dielectric Voltage Withstand The power supply shall withstand for 1 minute without breakdown the application of a 60Hz 1500V AC voltage applied between both input line and chassis (20mA DC cut-off current).
* T1 : Turn on time ( 2 sec. Max.) * T2 : Rise time ( ≦ 20mS Max.) * T3 : Power good turn on delay time ( 100 < T3 < 500 mS ) * T4 : Switch on time (0.5 sec. Max.) * T5 : Power hold-up time (16 mS Min.at 20%load) * T6: Power good turn off delay time ( 1.0 mS Min.) 100%load * Power on-off cycle : When the power supply is turned off for a minimum of 2.0 sec. and turn on again, the power good signal will be asserted. 10. MTBF The MTBF of the power should be 100,000 hours min. 11. Burn-In 11.
EN Power supply connector overuse definition A single PCIe 8pin cable and connector’s maximum current rating is 12.5A, which is 150W (+12V x 12.5A). So SilverStone’s warranty will not cover damages or malfunction resulting from the use of a graphics card or expansion card with a single PCIe 8pin connector that exceeds standard 225W total power draw (150W from PCIe 8pin connector + 75W from PCIe motherboard slot).
RU Определение чрезмерной нагрузки на коннектор блока питания Один кабель и коннектор PCIe 8pin поддерживает ток 12.5A, что равно 150Вт (+12В x 12.5A). Таким образом, гарантийные обязательства SilverStone не будут действовать если вы используете видеокарту или другую карту расширения с одним коннектором PCIe 8pin, которые превышает стандартную общую потребляемую мощность 225Вт (150Вт через коннектор PCIe 8pin + 75Вт через слот PCIe материнской платы).
TH ขีดจำกัดการรองรับการใช้งานของขั้วต่อจากพาวเวอร์ซัพพลาย สำหรับขั้วเชื่อมต่อและสายไฟเลี้ยง PCIe 8 พินสามารถรองรับกระแสได้สูงสุด 12.5 แอมป์หรือหมายถึง 150 วัตต์ (+12V x 12.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. ※付属の電源コードは当該製品専用です。他の機器に使用しないでください。 Please refer to SilverStone website for latest specifications updates.
NO.
