manual

ManualsBrandsSilverStone ManualsPower Supply UnitsST1000-PLUS

100% modular cables

24hour continuous power output with 40 C operating temperature

Efficiency 85%~88% at 20%~100% loading

Class-leading single +12V rail

Strict ±3% voltage regulation and low ripple & noise

Japanese main capacitors

Silent running 135mm fan

PCI-E 8pin and PCI-E 6pin connectors support

Support ATX 12V 2.3 & EPS 12V

Active PFC

Unparalleled combination of power, efficiency, and flexibility

September, 2009

NO.G11210670

SST-ST1000-P / ST85F-P / ST75F-P

STRIDER PLUS

Summary of content (6 pages)

PAGE 1
STRIDER PLUS SST-ST1000-P / ST85F-P / ST75F-P Unparalleled combination of power, efficiency, and flexibility 100% modular cables 24hour continuous power output with 40 C operating temperature Efficiency 85%~88% at 20%~100% loading Class-leading single +12V rail Strict ±3% voltage regulation and low ripple & noise Japanese main capacitors Silent running 135mm fan PCI-E 8pin and PCI-E 6pin connectors support Support ATX 12V 2.3 & EPS 12V Active PFC O September, 2009 NO.
PAGE 2
STRIDER PLUS SERIES SPECIFICATION SilverStone Strider Plus ST1000-P ST85F-P ST75F-P 2. DC OUTPUT 2.1 DC voltage regulation Range Min Nom. Max Unit +3.3V +/-3% +3.20 +3.3 +3.40 Volts +5V +/-3% +4.85 +5.0 +5.15 Volts +12V +/-3% +11.64 +12.0 +12.36 Volts -12V +/-10% -13.20 -12.0 -10.80 Volts +5VSB +/-5% +4.85 +5.0 +5.
PAGE 3
STRIDER SERIES STRIDERPLUS ST1000 ST1000-NV 2.3 Output Ripple 2.2.2: 850W(ST85F-P) Load Range Parameter Min 2.3.1 Ripple regulation Nom Max Peak Unit Parameter Ripple&Noise Unit 0 20 Amps +3.3V 50 mVp-p +5V 0.5 25 Amps +5V 50 mVp-p +12V 0.1 67 Amps +12V 120 mVp-p -12V 0 0.3 Amps -12V 120 mVp-p +5VSB 0.1 3.5 Amps +5VSB 50 mVp-p +3.3V 72 1.Maximum continuous total DC output power should not exceed 850W. 2.Maximum continuous combined load on +3.
PAGE 4
STRIDER PLUS SERIES 2.4 Overshoot Any overshoot at turn on or turn off shall be less 10% of the norminal voltage value, all outputs shall be within the regulation limit of section 2.0 before issuing the power good signal of section 5.0. 2.5 Efficiency Power supply efficiency typical 85% at 115Vac normal voltage. 2.6 Remote ON/OFF control When the logic level "PS-ON" is low, the DC outputs are to be enabled. When the logic level is high or open collector, the DC outputs are to be disabled. 3.
PAGE 5
STRIDER PLUS SERIES 5.3 Altitude 3.7 No load operation No damage or hazardous condition should occur with all the DC output connectors disconnected from the load. The power supply may latch into the shutdown state. 10,000FT max Storage 50,000FT max 6. MTBF 4. TIMING 4.1 Signal timing drawing ~ 7. MECHANICAL REQUIREMENTS VAC T1 on PS-ON 7.1 Physical Dimension 150 mm (W) × 86 mm (H) × 160mm (D) T6 ~ off 95% ~ 7.2 Connectors M/B 24PIN connector ~ Signal Pin Orange +3.3V 13 Orange +3.
PAGE 6
STRIDER PLUS SERIES ATX 12V 4PIN (4+4PIN EPS 12V in split mode) Signal Pin Pin Signal Black GND 1 3 12V Yellow Black GND 2 4 12V Yellow 4PIN peripheral connector (HDD) 4PIN floppy connector (FDD) Signal Pin Pin Signal Yellow +12V 1 1 +5VDC Black COM 2 2 COM Black Black COM 3 3 COM Black Red +5VDC 4 4 +12V Yellow Signal Pin Pin Signal Yellow +12V 1 5 COM Black Yellow +12V 2 6 COM Black Yellow +12V 3 7 COM Black COM 4 8 COM Black Signal