manual

ManualsBrandsSilverStone ManualsPower Supply UnitsST85F-G

October, 2010

NO.G11212840

STRIDER GOLD

ST1200-G / ST1000-G / ST85F-G / ST75F-G

The perfect balance of performance, efficiency, and quality

Summary of content (6 pages)

PAGE 1
STRIDER GOLD October, 2010 NO.
PAGE 2
STRIDER GOLD SERIES SPECIFICATION STRIDER GOLD SERIES SST-ST1200-G SST-ST1000-G SST-ST85F-G SST-ST75F-G ATX12V / EPS 12V Switching Power Supply With Active PFC 80 PLUS Gold PS/2 This specification describes the requirements of 750W, 850W, 1000W, 1200W switching power supply with an stretch ATX form-factor and EPS12V, +5V standby voltage, remote on/off control, full range line input capability and forced air cooling characteristics . 1. AC INPUT 1.
PAGE 3
STRIDER SERIES STRIDERGOLD ST1000 ST1000-NV 1.Maximum continuous total DC output power should not exceed 850W. 2.Maximum continuous combined load on +3.3VDC and +5VDC outputs shall not exceed 150W. 3.Maximum current for +12V outputs shall be 70A (840W). 4.Maximum peak total DC output power should not exceed 950W. 5.Peak power and current loading shall be supported for a minimum of 12 second. 6.When +12V is load to 28A , -12V minimum load is 0.02A. 2.2.3: (ST1000-G Load Range) Parameter Min Max Unit +3.
PAGE 4
STRIDER GOLD SERIES 2.5 Efficiency Power supply efficiency typical 87%~90% at normal AC main voltage and 20%~100% load on all outputs. 2.6 Remote ON/OFF control When the logic level "PS-ON" is low, the DC outputs are to be enabled. When the logic level is high or open collector, the DC outputs are to be disabled. 3. PROTECTION 3.1 Over current protection The power supply shall have current limit to prevent the +3.3V,+5V,and +12V outputs from exceeding the values shown in the following Table.
PAGE 5
STRIDER GOLD SERIES 4. TIMING 6. SAFETY 4.1 Signal timing drawing Figure 2. is a reference for signal timing for main power connector signals and rails. 6.1 Underwriters Laboratory (UL) recognition. The power supply designed to meet UL 1950. 6.2 The power supply must bear the German Bauart Mark from TUV. 7. ELECTROMAGNETIC COMPATIBILITY (EMC) 7.1 IEC 61000-4-2 ESD LEVEL X20KV4. 7.2 IEC 61000-4-3 radiated electrical field requirement. 7.3 IEC 61000-4-4 BURST . 7.4 IEC 61000-4-5 surge Voltages 7.
PAGE 6
STRIDER GOLD SERIES 9.2 Connectors M/B 24PIN connector 4PIN peripheral connector (HDD) Signal Pin Pin Signal Orange +3.3V 13 1 +3.3V Orange Blue -12VDC 14 2 +3.3V Orange Black COM 15 3 COM Black Green PS-ON 16 4 +5VDC Red Black COM 17 5 COM Black Black COM 18 6 +5VDC Red Black COM 19 7 COM Black White N/C 20 8 PWRGOOD Grey Red +5VDC 21 9 +5Vsb Purple Red +5VDC 22 10 +12V Yellow Red +5VDC 23 11 +12V Yellow Black COM 24 12 +3.