Owner`s manual
117
location of the garboard drain plugs).
Some compartments in the bilge may not
drain completely due to the position of the
yacht. Pump these compartments out with
a portable pump and then use a sponge to
remove all remaining water.
The procedure for draining and winterizing
the fresh water system is as follows:
❏ Drain the fresh water supply tank by
opening the hot and cold faucets in the
galley for ten (10) minute intervals until the
tank is empty.
❏ Open all faucets in the galley, both
showers, both head sinks and the exterior
cockpit shower.
❏ Remove the fresh water filter bowl and
strainer. Clean, dry and replace strainer
bowl.
❏ Drain the water heater and remove the
cold water intake hose and hot water
output hose and hook them together.
❏ Remove the inlet hose from the fresh
water tank (See Mechanical Layout in the
Schaematis Scetion of this Owners
Manual, which illustrates the location of
the fresh water tank) and insert it into a
container of non-toxic, fresh water anti-
freeze. Turn the fresh water pump ON and
starting at the farthest faucet from the
pump, turn ON all faucets until the anti-
freeze flows out.
❏ Turn OFF the fresh water pump and
reconnect the inlet hose to the fresh water
tank.
❏ Pour non-toxic anti-freeze into all sink
and shower drains until the liquid is dis-
charged overboard.
Alternate procedure for draining and
winterizing the fresh water system is as
follows:
❏ Drain all water from the fresh water tank.
❏ Drain all water from the water heater.
❏ Remove hose from the input side of the
fresh water pump and allow to completely
drain.
❏ Remove hose from the output side of the
fresh water pump and turn ON all faucets.
❏ Blow compressed air (15-20 lbs. psi)
through the output hose until all water
stops flowing from the faucets.
❏ Leave water lines at the fresh water
pump disconnected to allow any trapped
water vapor to drain and evaporate.
The procedure for draining and winterizing
the marine sanitation system is as follows:
❏ Drain all water lines into the waste
holding tank. Continue to flush fresh water
into the waste holding tank and pump out
into an approved waste facility until thor-
oughly clean.
❏ Add non-toxic, freshwater anti-freeze to
the waste holding tank by flushing through
the toilet.
❏ Run the macerator pump to allow anti-
freeze to flow through the pump and the
input/output lines.
❏ Remove the drain plug from the macera-
tor seacock while the valve is closed and
allow the line to drain. Replace the drain
plug.