User's Manual

StreamCaster MIMO Radio User Manual 12/19/18
10017C000 Silvus Technologies Confidential Page
88
Settings:
Figure 42 Spectrum Scan Settings
Clicking the settings button at the top left of the window will show the settings pane as shown in
Figure 42 Spectrum Scan Settings The node list shows the list of nodes currently connected into the
mesh network. Any nodes selected will be used as part of the spectrum scan. Nodes that are
unchecked will resume normal operation. Note that an unchecked node will continue
transmitting in the frequency channel it is operating in and its transmission will show up in the
scan results of scanning radios.
Mode – Set to Spectrum Scan or Zero Span. Spectrum Scan mode provides plots of signal strength
over frequency. Zero Span provides a plot of power over time in a 20MHz Bandwidth (see Figure
44 Zero Span Results below.
Spectrum Scan Mode:
Center Frequency – Specify the center frequency of the scan.
Span – Specify the span of the scan, centered on the center frequency. (e.g. Center freq
of 2450MHz and span of 100MHz will scan 2400-2500MHz). A large span will take longer
to complete.