User's Manual

StreamCaster MIMO Radio User Manual 12/19/18
10017C000 Silvus Technologies Confidential Page
89
Antenna Mask – Choose which antenna on the radio to use for scanning. If there are 2
antenna radios in the network antenna 1 or 2 must be chosen.
Resolution Bandwidth – Specify the RBW for the scan. A smaller RBW will provide a more
detailed plot, but will take longer to complete the scan. 625KHz is a good balance between
scan detail and time of scan.
Threshold – Specify the threshold for measurement of the duty cycle of interference.
Duration – Duration of each scan. A longer duration will provide better accuracy but will
take longer to complete.
Approximate time for scan – Approximate time that the network will be down for the
scan to complete.
Zero Span Mode:
Figure 43 Zero Span Settings
In the Zero Span mode, the radio will provide a plot of the power measured in a 20MHz
bandwidth across time. Zero Span can only be conducted on one radio in the network at
a time. Other radios in the network will continue to operate and transmit so a zero span