Projector User and Installation Manual

14
8 REMOTE CONTROL
Insert the batteries, taking care to match the polarity, as indi-
cated in the battery recess of the remote
(Fig. 24).
+
-
+
-
+
-
+
-
Fig. 24
Change the batteries in the remote control if experiencing
difficulty in sending commands to the projector.
If the remote control is not to be used for a long period of time
remove the batteries. Replace all batteries at the same time; do
not replace one new battery with a used battery. If the batteries
have leaked, carefully wipe the case clean and replace with
new batteries.
The remote control sends commands to the projector via in
-
frared signals.
It is possible to control the projector by pointing the remote
control at the screen; the sensor at the front of the projector will
pick up the reflected infrared commands.
(Fig. 25).
C-SY
NC
D
VI
F1
ZOOM
LIGHT
Fig. 25
Avoid placing obstructions between the remote control and the
infrared sensor at the front of the projector; this will impair the
remote control performance.
four 1,5 V
AAA type
batteries