User manual

CRYSTALCUBE—User Manual
Rear view
ITEM LABEL DESCRIPTION SEE PAGE
1.
AC IN Connect the POWER cable
10
2.
3D SYNC Connect the SIM2 3D glasses IR transmitter
3.
HDMI 1 Connect the HDMI cable from a HDMI device
4.
HDMI 2 Connect the HDMI cable from a HDMI device
5.
(USB)
Connect the USB cable from a computer
6.
VGA IN Connect the RGB cable from a computer
7.
RS-232C Connect RS-232 serial port cable for remote control
8.
COMPONENT Connect the Component cable from a component device
9.
USB POWER For USB charge support DC 5V
10.
VIDEO IN Connect the COMPOSITE cable from a video device
11.
S-VIDEO Connect the S-VIDEO cable from a video device
12.
AUDIO OUT Connect an AUDIO cable to audio amplifier
13.
DC 12V TRIGGER
When connected to the screen through a commercially available cable,
the screen deploys automatically on start up of the projector. The screen
retracts when the projector is powered off (see notes below).
Note: do not use a 3.5mm mono type cable; use a 3.5mm 3 pin type
stereo cable
– 3 –