User manual

CRYSTALCUBE—User Manual
– 41 –
LED Error Messages
ERROR CODE MESSAGES
POWER LED
GREEN
LAMP LED
RED
TEMP LED
RED
System Initial
Flashing OFF
OFF
Ready to Power on (Standby)
ON OFF
OFF
System Power on
Flashing OFF
OFF
Lamp Lit , System stable
ON OFF
OFF
Cooling
Flashing OFF
OFF
Over Temperature
ON OFF
ON
Thermal Break Sensor error
4 blinks OFF
OFF
Lamp Fail
5 blinks ON
OFF
Lamp Temperature shut down
5 blinks 1 blinks
OFF
Lamp Short circuit in output detected
5 blinks 2 blinks
OFF
Lamp End of lamp life detected
5 blinks 3 blinks
OFF
Lamp did not ignite
5 blinks 4 blinks
OFF
Lamp extinguished during normal operation
5 blinks 5 blinks
OFF
Lamp extinguished during run-up phase
5 blinks 6 blinks
OFF
Lamp voltage got error
5 blinks 7 blinks
OFF
Lamp ballast got error
5 blinks 8 blinks
OFF
Ballast watt value is out of range
(Lamp Normal & Eco mode)
5 blinks 9 blinks OFF
Lamp ballast Communication error
5 blinks 10 blinks
OFF
Fan-1 error
6 blinks 1 blinks
OFF
Fan-2 error
6 blinks 2 blinks
OFF
Fan-3 error
6 blinks 3 blinks
OFF
Case Open
7 blinks OFF
OFF
DAD1000 error
8 blinks OFF
OFF
Color wheel error
9 blinks OFF
OFF
In the event of an error, please disconnect the AC power cord and wait for one (1) minute before restarting
the projector. If the Power or Lamp LEDs are still blinking or any other situation that isn't listed in the chart
above
, please contact your service center.
Image Problems
Problem: No image appears on the screen
1. Verify the settings on your notebook or desktop PC.
2. Turn off all equipment and power up again in the correct order.
Problem: The image is blurred
1. Adjust the Focus on the projector.
2. Press the Auto button on the remote control.
3. Ensure the projector-to-screen distance is within the specified range.
4. Check that the projector lens is clean.
Problem: The image is wider at the top or bottom (trapezoid effect)