User guide

◦ Memories
◦ 3D Controls (3D Mode and Input Formats)
Operation
The SUPERLUMIS projector has two IR receivers, one on the front and one on the back
of the unit. The operative range of the remote control is approximately 10 m (33 ft.).
Make sure that there is nothing obstructing the infrared beam between the remote
control and the IR receiver you are pointing to. You can point the remote control
towards the screen, as the IR beam is reflected by the screen towards front IR receiver
of the projector. In this case the effective range of the remote control may be smaller
than declared.
Batteries
To install batteries in the remote control:
1. Open the battery cover.
2. Insert four AAA (LR03) batteries making sure the polarities match the + marks
inside the battery compartment.
3. Replace the cover.
Replace the batteries with new ones when the operating range of the remote control
decreases. Dispose of used batteries according to local regulations. Make sure you do
not mix old and new batteries or different types of batteries.
Warning: If you will not use the remote control for a long time, remove the batteries
to avoid battery leakage.
Projector Keypad
turns the projector on or off
◂ ▸ ▴ ▾
select menu items, adjust settings or switch test patterns
MENU enters OSD Main menu and selects the desired section
ESC exits OSD
SOURCE/O enters OSD Input menu/selects a menu item
2 Overview SUPERLUMIS
User Guide
11