User`s manual

SFX-10 Video Mixer Basic Operations

Typical Auto FADE/WIPE

Step 1 Push slide on Video Source Select to the top “A” position.

Step 2 Select video inputs for Source A and Source B by pushing

the appropriate button(s).

Source Selection

Step 3 Select WIPE from the MODE CONTROL panel.

TIP: We will use WIPE for purposes of this example. However, the

AUTO mode will work in combination with whichever button

(WIPE, KEY, MIX, or PIP) is selected in the MODE

CONTROL panel.

Mode Selection

Step 4 Select one of the wipe patterns by pressing the appropriate

button in the FUNCTIONS control panel. (Wipe patterns

are indicated by the icons in the purple color-coded area.)

TIP: After selecting the desired wipe pattern, perform the wipe

manually by moving the slide control in the Video Source

Select control panel. If the wipe pattern is the one desired, reset

the slide to the top “A” position before proceeding.

Wipe Selection

Step 5 Press the ON button (blue) in the AUTO FADE/WIPE

section of the MODE CONTROL panel.

TIP: Once pressed, the ON button changes the function of the Video

Source Select slide control. The slide now controls the speed of

the auto wipe. (This is indicated in the blue color-coded type

above it.)

Auto Wipe/Fade Selection

Step 6 Position the slide control where desired to set the speed of

the auto wipe.

TIP: The speed of the auto wipe is determined by the setting of the

control slide. The top “A” position is fastest. The bottom “B”

position is slowest.

Set Speed

Step 7 Press the START button to execute the automatic wipe. The

wipe is illustrated below the Step 7 diagram at right

Auto Wipe/Fade

TIP: You can change the speed of the transition while the auto wipe is

in progress by moving the slide control. The red LED light on

the START button will stay lit for the duration of the auto wipe.

Pressing the START button a second time during the auto wipe

will pause the transition. Press a third time to resume progress.