Speaker Selectors Models SSW-L4 EX and SSW-L6 EX User Manual SSW-L4 EX (bottom) and SSW-L6 EX (top)
Table of Contents Important Safety Precautions .................................................................................... 2 What’s Included........................................................................................................... 2 Introduction ................................................................................................................. 3 Front Panel ................................................................................................................
Introduction The Sima speaker selector series has been designed to let you add speakers around your home or office while maintaining a central control. Turn them on and off and adjust the volume without requiring additional amplifiers.
Typical Hook up Figure 3, Overview of typical system hook-up. (SSW-L6 EX shown) Installation Tips • • • • • It is recommended to use 18 or 16 AWG gauge stranded wire. For runs longer than 50’, 14 gauge is recommended. You can mix 4, 6, 8 and 16 ohm speakers. Since speakers have different efficiencies, more efficient speakers will sound louder than less efficient speakers.
Operation Initial connection It is recommended that you select only one speaker pair in the same room you are in for initial turn on. Select this speaker pair and turn on your receiver/amplifier. Make sure sound is coming from both speakers. Before you turn on additional speakers, read the information below. Level Controls Turning the level control fully counter-clockwise to the OFF position will turn that speaker pair off.
Sima Products Corp. 125 Commerce Dr. Hauppauge, NY 11788 USA Visit us at www.simproducts.com E-mail us at: customerservice@simaproducts.