STP-120 Power Inverter Model STP-120 120 Watt Portable Power inverter With Car/Airplane adapter and USB & AC 110/120V Power Output © 2007 Sima Products Corporation 140 Pennsylvania Ave. Bldg #5 Oakmont, PA 800-345-7462 www.simaproducts.com PN21751 Page 20 User’s Manual Register your product at www.simaproducts.
STP-120 Power Inverter Table Of Contents STP-120 Power Inverter Notes Table Of Contents ...................................... 2 Important Safety instructions...................... 3 Warnings & Cautions.................................... 4 Introduction ................................................ 9 Features......................................................... 9 Operating instructions .............................. 11 Operation of the 110/120V AC outlet.........
STP-120 Power Inverter STP-120 Power Inverter Important Safety instructions To reduce the risk of injury, user must read and understand this instructional manual. This manual contains important information regarding the operation and warranty of this product. Please keep for future reference. Please read all the Cautions and Warnings before installing and using the power inverter.
STP-120 Power Inverter STP-120 Power Inverter Warnings & Cautions To reduce the risk of fire, electric shock, explosion or injury: • • • • • • Do not connect to AC distribution wiring. Remove appliance plug from outlet strip or turn off inverter before working on the appliance. Power strips with switches and circuit breakers only interrupt power to the “hot” receptacle terminals. The “neutral” terminals remain powered with respect to the ground terminals. Not approved for ignition protected areas.
STP-120 Power Inverter Troubleshooting Common power problems Possible causes Recommendations Battery voltage Recharge battery or check DC below 9.5 – 10.5 power supply volts Equipment being Reduce load to maximum of operated draws too 120 watts much power Inverter in thermal Allow the inverter to cool. Be shutdown condition sure there is adequate ventilation around the unit.
STP-120 • • • • • • • • Power Inverter This inverter will not operate high wattage appliances that produce heat such as hair dryers, microwave ovens and toasters. Do not use with a positive ground electrical system. Reverse polarity connection will result in a blown fuse and may cause permanent damage to the inverter. The majority of cars, trucks, RVs and boats in the U.S. are negative ground. This inverter is not tested for use with medical devices. Do not open the inverter.
STP-120 Power Inverter Protective Features The inverter monitors these conditions: Low Battery Voltage – This condition is harmful to the inverter, but could damage the power source, so the inverter will automatically shut down when the input voltage drops below 9.5 – 10.5 volts DC. Input Voltage Too High – The inverter will automatically shut down when the DC input exceed 15 volts. Thermal Shutdown – The inverter will automatically shut down when the unit becomes over heated.
STP-120 Power Inverter STP-120 Power Inverter Operation of the USB Power port CAUTION: There are a few battery chargers that are not compatible with modified sine wave operation. These are typically small rechargeable, battery-operated devices like razors and flashlights that can be plugged directly into an AC receptacle to recharge. Some chargers for battery packs used in power tools also should not be used with an inverter.
STP-120 Power Inverter STP-120 Power Inverter Operation of the 110/120V AC outlet Introduction 1. 2. Thank you for purchasing the Sima’s new portable power inverter. This inverter can be used to operate personal electronics and mobile office equipment such as laptop computers, digital/video cameras, MP3 players, cell phones, PDAs and more. It can also be used to charge 110/120V AC devices that have an appropriate recharging adapter with a standard North American 3-prong plug.
STP-120 • • • Power Inverter Automotive and airplane 12V DC adapters 5 V DC USB port Bi-color Power/Fault LED STP-120 Power Inverter Operating instructions Once properly connected to a 12V DC power source, the bi-color LED indicator will light up green when the power is on. ALWAYS TURN THE INVERTER ON BEFORE THE CONNECTED DEVICES The standard 110/120 V AC and USB outlets allow the user to operate multiple devices at the same time. Simply plug the equipment into the unit and operate normally.