Specifications

YES
NO
Additional operator protection shall be provided by a seat bar, which shall prevent
lift arm and tilt operation, activate brakes, and prevent starting engine when
devise is not in operating position
Upper torso restraint must be provided for use with two-speed drive.
Grab handles must be provided as standard equipment to assist the operator
mounting and dismounting the loader.
When boom is in lowered carry position operator must have 360° degree
unobstructed vision from operator seat.
BUCKET
84” Dirt/construction bucket with reversible bolt on cutting edge 27 cu. ft. minimum
OPERATOR AREA
Deluxe headliner, rear window emergency exit, deluxe suspension seat with
padded restraint bar
Gauges such as hour meter, fuel, engine temp., warning lights for hyd. temp,
engine coolant, and battery charge seat belt and hyd. filter indicator shall be
standard
2” Adjustable seatbelt shall be standard
Hand and foot operated throttle control shall be standard equipment
Steering in left hand for forward/reverse and left/right steering standard
Right side mounted pilot lever for lift, lower curl back and dump and float position
shall be standard equipment.
Cab must be capable of being raised for maintenance by removing (2) bolts and
pumping up cab with manual pump in rear of machine, by one person
STANDARD EQUIPMENT
Cab Enclosure with Heat and Air Conditioning:
Cab shall be a R.O.P.S guard with integral side screens, with sliding glass side
windows, front glass door with windshield wiper and washer
Cab enclosure must come with heat and air conditioning installed at factory.
Cab must have a dome light
ATTACHMENT
OPTION 1 COLD PLANER:
Shall have all necessary hoses and couplers to fit Gehl V400
Planer must have a minimum of 30” cutting width
Cutting depth minimum of 6”
Tilt capability right or left 7 ½° degrees
Shipping weight minimum of 2,200lbs
Planer must have an open center drum design (no solid drums)
Planer must have four (4) outer leveling wheels with seal bearing
Planer must have no more than three (3) hydraulic lines and couplers.
Unit must have 3-position electronic controller to operate side shift, depth and tilt
Planer must have a minimum of 78 pics.
Planer must use high flow auxiliary hydraulics minimum of 40 G.P.M.
Side shift shall be a minimum of 24” travel.
Planer must have a front access door with hinges and turn buckles to tighten.
Planer must utilize center pivot design which puts the force of the skid steer
directly over the cutting drum.
Main carrier bearings shall be greasable.
Unit shall come equipped with correct flat faced couplers to fit high-flow side of
Gehl V400