Specifications

YES
NO
Rear Clearance Radius Maximum 5’ 9”
PERFORMANCE
Cycle Time Raise Full Load Minimum 4.6 sec
Lower No Load Minimum 2.8 sec
Dump Full Load Minimum 3.1 sec
Curl Full Load Minimum 2.3 sec
Travel Speed – Low Minimum 0-4.9 mph
Travel Speed – High Minimum 0-7.4 mph
Rated Tipping Load Capacity (SAE) Minimum 8,102 lbs
Rated Operating Load (SAE) 50% Tip Minimum 4,051 lbs
Rated Operating Load (SAE) 35% Tip Minimum 2,833 lbs. SAE J818
Bucket Breakout Force Minimum 8,670 lbs
Lift arm Breakout force Minimum 8,550 lbs.
Ground Pressure Minimum 4.6 PSI
STANDARD FLUID CAPACITIES
Fuel Tank Minimum 23.8 gallons
Hydraulic Reservoir Minimum 15.9 gallons
Total Hydraulic System Capacity Minimum 25.1 gallons
Engine Oil Minimum 13.9 quarts
Engine Coolant Maximum 17.4 quarts
OPTIONAL ATTACHMENTS FOR TAKEUCHI TL12CH OR EQUAL:
1. Option 1 ASPHALT COLD PLANER UNIVERSAL MODEL AP-600HD
Planer must have a minimum of 24” cutting width
Cutting depth minimum of 6”
Tilt capability right or left 15° degrees
Shipping weight minimum of 1,900lbs.
Planer must have an open center drum design
Planer must have four outer leveling wheels
Planer must have three hydraulic lines with swing-away hydraulic controls for tilt,
side shift and depth.
Planer unit must be direct drive; planetary unit will not be acceptable.
Planer must have a minimum of (68) low torque asphalt pics
Planer must use high flow auxiliary hydraulics
Side shift shall be a minimum of 24” travel
Planer must utilize center pivot design which puts the force of the skid steer
directly over the cutting drum
Electronic installation kit to plug into Skid Steer Loader to operate all functions
from inside the cab while milling
55 Gallon water tank mounted to roof of skid steer, low profile design
Water kit must use a gravity fed system
Planer must have a universal coupling system allowing the unit to work on a
variety of skid steers
Hydraulic quick couplers must connect to Skid Steer Loader
Unit must come complete with one year machine warranty.
Dealer must install unit onto Skid Steer
Dealer must include training on the planer