Specifications

YES
NO
TARP SYSTEM:
The Arms Are Powered By (2) Powerpack Spring Assemblies
Mounted On The Side Of The Dump Body.
The Springs Must Be Fully Encased, For Safety And Protection,
In A Polished Aluminum Two-Piece Casting.
For Replacement Purposes, The Spring/Arm Assemblies Must
Be Universal To Eliminate The Need For Driver-Side And
Passenger-Side Components.
The Springs Must Have The Ability To Be Pre-Loaded With
Tension By Simply Rotating The Pivot Post Without Adding
Additional Mounting Holes To The Dump Body.
The Arm Assembly Shall Consist Of Four (4) Pieces Of High
Strength 6061 T6 Aluminum Extrusions With At Least A
Minimum Wall Thickness Of .188 For The Ends Of The Tube
For Strength Purposes.
All Arm Components Must Be Polished. The Arm Sections Shall
Telescope To Allow For Length And Width Adjustment, And
Must Be Easily Replaceable.
Arms Should Be Angled At Approximately 26 Degrees To Allow
The Arms To Be Recessed In The Open Position.
To Minimize Friction And Wear Within The Tarp Pocket, The
Rear Cross Tube Shall Be Round.
The Roll-Up Tube Assembly Is To Be A 6061 T6 Aluminum
Extrusion With Zinc Plated Steel Machined End Shafts.
It Shall Be A Telescoping Design So The Width Can Be
Adjusted Without Cutting The Roll-Up Tube.
The Roll-Up Tube Shall Be Designed So The Tarp Can Easily
Be Attached Without Drilling Any Holes.
The Roller Assembly Mounting Plates Shall Be Polished
Aluminum With High- Speed Flanged, Pre-Lubricated Bearings.
A One-Pieced Polished Aluminum Wind Deflector Is To Be
Secured To The Roller Assembly Mounting Plates.
To Minimize Installation Time, The Wind Deflector Must Be
Designed So No Cutting (To Length) Or Drilling Is Required.
The 12-Volt Electric Motor Shall Have A Right-Angle
Gearbox With A Removable Chrome Plastic Cover.
The Gears Must Be Hardened And Ground Steel, Encased In
A Metal Housing, And Shall Be Designed To Ensure The Tarp
Cannot Back-Drive.
The Cab Installed Rocker Switch Is To Be Self-Centering,
Constructed Of Metal.
A Reverse Dc Contactor And All Necessary Wire Fasteners
And Electric Hardware Shall Be Furnished. The Motor Shall
Carry A Three (3) Year Non- Prorated Warranty.
The Systems Shall Include A Double-Arm That Is Attached To
The Primary Swing Arms.