Specifications

YES
NO
Track rollers shall be out-side running, permanently sealed, w/precision material
face seals
Loader must have two-speed transmission as standard equipment
Loader must have outboard double reduction planetary final drives for durability
and efficient power transfer to tracks.
Sprockets run off planetary drives to be a minimum of 17” diameter
Undercarriage must have double rear idlers mounted on the outside of track
a minimum of 12” diameter
A large front idler shall be 17” minimum diameter.
Undercarriage shall be a one-piece welded chassis.
(No moving suspension parts or exposed hoses.)
Loader shall be equipped w/permanently mounted side frames.
Ground contact of tracks 58.9” minimum
Structural cross-members must be integrated into the framework
CONTROLS
Pilot operated hydraulic joystick controls with button mounted on front of drive
lever for high/low speed, via a trigger. (No electric over hydraulic joysticks will be
accepted)
Forward, reverse, speed, and steering must be controlled single pilot operated
joystick with hydraulic power assist.
Loader arm and bucket functions shall be controlled by single pilot operated
joystick
Must have electric over hydraulic control of the loader arm float with detent
position
Unit must have foot and hand throttle
Working mode switch, for 3 settings; power, normal and economy
LOADER
Loader must come equipped with “Ride Control” to help retain material in bucket
Loader arms must be a radial lift design
Lift and tilt functions to be controlled by a right hand joystick.
Loader must have two lift and two dump cylinders.
Bucket float position must be engaged by a push button on the right hand joystick
control lever.
A maximum of 12-Pivot Pins on entire loader arm design.
Hoses must be guarded for abrasion resistance.
Front attachments must be a universal style quick coupler.
Loader arm must feature hydraulic bucket self leveling (up only).
Hydraulic quick attach shall be standard and operated from inside cab and
shall work off of pilot pressure
Quick attach must be equipped w/adjustable bucket dump stops to prevent hyper
extension of bucket tilt cylinders.
Loader arms cylinder must have cushioned arm cylinder to reduce shock.
Loader arm must not have exposed hydraulic lines and must be steel, with
exception to pivot points
(No exposed hoses at pivot points will be accepted)