Specifications

YES
NO
AUXILIARY CONTROLS
Auxiliary hydraulic circuit must be two-way (dual acting) and must be plumbed
to end of loader arm.
Auxiliary hydraulic controls must be operated by push-button on joystick
Must have proportionate rocker.
Proportional rocker switch control for auxiliary hydraulics w/detent function shall
be included as standard, on joystick.
14-Pin electrical connector mounted on outside of machine, push button control
on right joystick included as standard
Auxiliary hydraulic select settings (3-position) 100%, default to 75%, default to
50% to match flow requirements for different attachments.
INSTRUMENTS
Instrument LED/LCD panel and condition indicators mounted right side within the
operators line of sight.
Charging system warning light
Coolant temperature warning ligh
Hydraulic temperature warning light
Engine preheat indicator light, illuminated until pre-heating is complete
Engine power mode indicator (POWER MODE)
Engine mode indicator (ECO MODE)
Auxiliary hydraulic work mode indicator (I, II, III) work modes
Engine fault warning light
Engine oil pressure warning light
Air filter restriction warning light
Hydraulic filter restriction warning light
High speed travel indicator
Bucket float indicator
Date Center: hour, meter, tachometer
Machine must be equipped with emergency engine shut down switch.
GAUGES (The following three gauges shall be standard)
Fuel
Coolant temperature
Hour meter gauges
HYDRAULICS: (Machine shall be equipped standard with high flow
hydraulics)
Unit must have an independent steel hydraulic reservoir mounted outboard for
easy access
(Plastic hydraulic tanks will not be accepted)
Large rear hydraulic cooler shall swing out of the way for good engine access
Standard auxiliary flow shall be a minimum of 20.0 G.P.M
Auxiliary high flow shall be a minimum of 36.3 G.P.M
Loader must have a gear type pump.