Specifications

YES
NO
Actual working hours/machine idle hours
Attachment usage hours
Machine travel hours
Machine load analysis
Operating mode ratios
Location and Asset Management
GPS location/Operation maps Out-of-area and movement alert with
location and time
Engine, nighttime and calendar lock
Maintenance Management
Service meter reading
Maintenance replacement notifications
Cautions/Abnormality codes
COUPLER SYSTEM
The wheel loader shall be equipped with a male master located on the
boom arms which shall be compatible with the bucket specified. It shall
be activated by means of a switch located within the operator’s
compartment
BUCKET
The wheel loader shall be equipped with a multi-purpose type bucket
rated by SAE standards at not less than 3.25 cu. yd. at a density of not
less than 2700 lb./yd. The bucket shall be not less than 108" wide and
shall be equipped with a bolt-on cutting edge. It shall be equipped with a
female coupler component as described in the section on the coupler
system.
SPARE PARTS PACKAGE
The wheel loader specified shall be supplied with the following spare
parts package:
One (1) Complete Set of Radiator Hoses
w/ Clamps
Three (3) Complete Sets of All Filters
One (1) Complete Set of All Belts
One (1) Grease Gun
w/ One (1) Case of Cartridges
Two (2) Spare Keys
Only original equipment manufacturer's genuine replacement parts shall
be quoted. Generic parts will not be accepted.
A listing of parts bid by part number must be submitted as part of the bid
One complete set of operators and parts manual
Four (4) set of keys
COMPLIMENTARY MAINTENANCE PROGRAM
The successful bidder shall perform periodic maintenance on the
machine being offered at no charge. It shall include, but not be limited to,
the following service at the noted hourly intervals: