Specifications

YES
NO
HEATED
LIQUID TACK
30 gallon capacity tank shall be supplied to transport and heat asphalt tack
coatings.
Interior, gravity feed designed tank will be of continuous welded 14 gauge
steel.
The bottom surface of the interior tank to be insulated with high
temperature refractory ceramic insulation and stainless steel in order to
protect from overheating material.
The outer shell of the tank shall be fabricated of 16 gauge steel, all welded
seams.
High temperature insulation along with a third wall of reflective aluminum
shall be attached to the outer shell to aid in heating efficiency.
A 1” on/off ball type valve with spout will be supplied to draw the
material.
The lid will be a weather resistant enclosure attached by hinge with
lockable latch.
TANK
(OPTION 1)
The heated storage unit will be bolted on with not less than 3/8” hardware
and removable if required.
A 10,000 BTU propane gas vapor burner will provide heating for material.
Convection heating will transfer energy to the tank and material.
The burner will be thermostatically controlled from 0-150 degrees
Fahrenheit.
Power to operate the gas control to be supplied by a 750 MV power pile
generator with 100% safety shutdown.
An electric Piezo igniter provides manual pilot ignition.
The thermostat will be supplied with a stop pin to limit the maximum
temperature setting and avoid possible material overheating.
LIQUID TACK
A positive displacement, iron gear pump with built in pressure relief valve
will provide the ability to spray 3 GPM of tack coating.
The pump shall be pre-piped and supplied with an application wand and
15 feet of hose.
SPRAY PUMP
(OPTION 2)
The pump will be driven by a 5.5 HP gasoline engine.
The piping to be complete with a valve and hose for flushing the suction
piping, pump and wand with water after each use.
This option requires the purchase of the Heated Liquid Tack Tank option
(above).
SOLVENT
UTILITY
TANK
(OPTION 3)
A 7 gallon capacity utility tank shall be supplied for use with cleaning
fluids.
The tank will be manufactured of 16 gauge welded steel.
A 3/4” on/off ball type valve with spout will be supplied to draw the
material.
The tank to be bolted on with not less than 3/8” hardware and removable if
required.