Specifications

YES
NO
Operator R.O.P.S/F.O.P.S cab must be capable of rotating backward for
maintenance
Cab front roll-up door must be ½” Polycarbonate
Braking: shall be spring applied, hydraulically released, multiple wet friction disc
brakes
that automatically engage when lap bar is raised or engine is shut off.
Rear work lights must be recessed into cab to prevent breakage.
Track loader shall have two rear and two front work lights
Unit must be equipped with a hydraulic activated back-up alarm
Seat belt will be provided.
Additional operator’s protection shall be provided by a seat bar which shall
prevent lift-arm and tilt operation, auxiliary hydraulics, and activate brakes when in
the up position
Grab handles must be provided to assist the operator with mounting and
dismounting
of the loader and must be replaceable (bolt-on).
The track loader must include a horn and a back-up alarm as standard equipment
The loader shall be painted Red and Gray.
Loader shall have a hydraulic quick attach lock and unlock switch in cab
STANDARD FEATURES
Must be equipped with selectable power modes allow the operator to match the
engine performance to the job.
Eco mode can provide up to 15% fuel savings while still offering maximum torque
and good power characteristics
Normal mode offers a good mix of power and economy for general work,
approximately 97% of the engine rating
Power mode produces peak engine power for maximum performance
Eco mode limits engine speed to 2,400 rpm.
When engine load is less than 30%, speed will decrease to 2,040 rpm after
8 seconds
When power demand exceeds 30% the engine speed will return to the throttle
position setting
Must have the capability to control regeneration with 3-modes
3-Position Regeneration Switch
1
st
Prohibit Regeneration Mode:
Prevents active regeneration in sensitive environments
2
nd
Auto Regeneration Mode:
Allows active regeneration when necessary to extend the life of the
Diesel Particulate Filter (DPF).
3
rd
Manual Regeneration Mode:
Allows the operator to enter into active regeneration if necessary
Must have variable flow auxiliary hydraulics offers three easy to select settings
that can be programmed to match the flow requirements of the attachment
Setting I 100% of Flow
Setting II 0-100% Factory default is 75%
Setting III 0-100% Factory default is 50%