Specifications

YES
NO
Improved arm float operation allow for easier detent also includes a status
indicator on the gauge panel.
BUCKET
Rubber track loader must come complete with a 76” heavy duty dirt/construction
bucket with 5/8” reversible bolt on cutting edge and side cutters
20.3 SAE heaped ft³ minimum capacity
DIMENSIONS
Length (w/bucket) Minimum 12’ 6”
Width to outside of tracks Maximum of 69.7”
Height Minimum 89.4”
Operating Weight Minimum 10,516 lbs.
Bucket Rating (heaped) Minimum 20.3 cubic ft.
Ground Clearance Minimum 12.8
Height to Bucket Hinge Pin Minimum 122.6”
Cutting Edge Clearance Height Minimum 93”
(Dirt Bucket – Full Dump)
Reach fully raised Minimum 34.4”
Angle of Departure Minimum 29.2°
Bucket Rollback at Ground Level Minimum 30°
Dump Angle at Full Height Minimum 38.5°
Dump Height Fully Raised Minimum 95.8”
PERFORMANCE
Cycle Time Raise Full Load Minimum 4.6 sec.
Lower No Load Minimum 3.0 sec.
Dump Full Load Minimum 3.0 sec.
Curl Full Load Minimum 2.0 sec
Travel Speed – Low Minimum 0-4.6 mph
Travel Speed – High Minimum 0-7.2 mph
Rated Tipping Load Capacity (SAE) Minimum 6,867 lbs.
Rated Operating Load (SAE) 50% Tip Minimum 3,434 lbs.
Rated Operating Load (SAE) 35% Tip Minimum 2,403lbs
Bucket Breakout Force Minimum 7,400 lbs.
Lift arm Breakout force Minimum 7,425 lbs.
Ground Pressure Minimum 4.4 PSI
STANDARD FLUID CAPACITIES
Fuel Tank Minimum 23.8 gallons
Hydraulic Reservoir Minimum 12.7 gallons
Total Hydraulic System Capacity Minimum 19.8 gallons
Engine Oil Minimum 14 quarts
Engine Coolant Minimum 16.4 quarts
VENDOR REQUIREMENTS
Two (2) set of keys used in the rubber track loader.
Two (2) set of operator’s parts & service manual in CD form.
Vendor shall maintain a fully equipped road service vehicle capable of performing
road service to the unit in the event that it may become inoperable in the field
Vendor must be local authorized representative for product being bid
Vendor must provide on site training for proper loader use.
Vendor is responsible for pick-up and delivery while under warranty.