User manual

User Manual VS-HD14 HDMI distribution amplifier Installation and Operation
5
Remote Control
• Power button to toggle device on/off
• 9 digit keypad (1 –2 –3-4 will be used to toggle between multiple units)
• Remote takes a 3v Lithium button battery.
• Replacement battery # CR2025 can be found at electronic retail stores.
Connecting and Operating the VS-HD14
How to Connect the 1x4 HDMI distribution amplifier to your devices
Use the connection diagrams on pages 8 and 9 for reference
1. Plug the 5V DC power supply into the1x4 HDMI distribution amplifier and connect to AC wall
outlet or power strip. The red Power indicator LED on the front panel will light up.
2. Connect the cable from your HDMI source into the HDMI input on the rear panel. The Input
indicator LED on the front panel will light up when the input is active.
3. Connect a cable from HDMI output #1 to the input on your monitor. The two devices will
communicate to identify HDMI compatibility. When compatibility is confirmed (about 15 seconds)
the Output #1 LED indicator will light up.
4. Connect additional monitors/displays to outputs #2-4 as needed.
Note: If the source and monitor cannot confirm HDMI or HDCP compatibility, the VS-HD14 reverts to
a default signal of 480p and may not have audio. When this default occurs, turn the monitor off for
about 10 seconds and then power up again to reset the connection.
When connecting multiple monitors of mixed HD formats, we recommend connecting an HDMI
monitor to output #1 The VS-HD14 assigns priority to output #1. For example, if a DVI monitor is
connected to output #1, outputs 2, 3 & 4 may not receive an audio signal, depending on the source
device.