Instruction Manual

850P Reference Dual-Mono Preamplifier
____________________________________________________________________________________
15
1. You may either continue where we left off in the
previous example by pressing “Setup” twice to
return to the main menu and the turn the
volume control until “IR CODE” appears in the
display OR enter into the “Setup” mode from the
beginning by pressing the “Setup” button and
rotating the volume control until “IR CODE”
appears in the display.
2. Press “OK” and “DEFAULT” will appear in the
display.
3. To change the RC-5 system codes, rotate the
volume control to scroll through the available
sets of RC-5 compatible codes: “SYS11”,
“SYS14”, “SYS15”, and “SYS19”.
4. Once you’ve decided on one, Press “OK” and
“SAVED” will appear briefly in the display
followed by “IR CODE”.
5. From this point you can (i) exit from the Setup
procedure by pressing the “Setup” button again
and “EXITING” will appear in the display or (iii)
continue with the Setup procedure by disabling
the infrared remote sensor, changing the IR
codes, resetting the 850P back to factory
default status (see the following example),
configure the 12 Volt Trigger Output or
configure more inputs (examples on previous
pages).
Reset the MOON 850P software settings back to their factory defaults:
1. You may either continue were we left off in the
previous example by turning the volume control
until “RESET” appears in the display OR enter
into the “Setup” mode from the beginning by
pressing the “Setup” button and then rotating
the volume control until “RESET” appears in the
display.
2. Press “OK” and “RESET N” will appear in the
display.
3. Rotate the volume control until “RESET Y”
appears in the display.
4. Press “OK” and “SURE ? N” will appear in the
display.
5. Rotate the volume control until “SURE ? Y”
appears in the display.
6. Press “OK” and “SAVED” will briefly appear in
the display followed by “RESET”.
7. Press the “Setup” button again and “EXITING”
will appear in the display.