Owner`s manual

MOON i-3 SE Integrated Amplifier
Remote Control Operation
The MOON i-3 SE Integrated Amplifier uses the ‘CRM’ full-function remote
control (figure 3). It operates on the Philips RC-5 communication protocol and is
can be used with other Simaudio MOON components.
The ‘CRM’ remote uses two AA batteries (included). To install them, simply slide
the back plate off in the direction of the arrow; insert the batteries in the correct
direction and then replace the back plate.
To engage the CRM remote for use with the MOON i-3
SE Integrated Amplifier,
you must first press the button labeled AMP.
The POWER button located on the upper left will switch the integrated amplifier to
either ‘Stand by’ or ‘On’ mode.
The 2 buttons labelled ◄ INPUT ► allow you to sequentially scroll, either
backwards or forwards, through all six (6) available inputs. For example, to switch
from the “CD” to the “A3” input you may press either
◄ INPUT three (3) times
or INPUT
► three (3) times. Pressing and holding down either of these
buttons results in only a single change to the selected input.
The 2 buttons labelled
◄ BAL ► allow you to control the channel balance.
Pressing ◄ BAL results in a decrease in the volume level of the right channel;
Pressing BAL
► results in a decrease in the volume level of the left channel. You
may either press and hold these buttons down or press them briefly to make
channel balance adjustments.
The 2 buttons labelled
▼ VOL ▲ allow you to control the volume level. Pressing
▼ VOL results in a decrease in the volume level; Pressing VOL ▲ results in an
increase in the volume level. You may either press and hold these buttons down or
press them briefly to make volume adjustments.
The MUTE button triggers a decrease in the output gain setting to a factor of 10%
of the current setting. For example, if your current setting was ‘30’ and you
pressed the “Mute” button, the gain setting will drop to ‘3’. Pressing the “Mute”
button a second time will reinstate the output gain level back to ‘30’.
Figure 3: CRM Remote Control
____________________________________________________________________________________
Remote Control Operation 10