Owner`s manual

MOON i 5.3 Integrated Amplifier
Remote Control Operation
The MOON i 5.3 Stereo integrated amplifier uses the ‘FRM-2’ full function, all aluminum
remote control (figure 4). It operates on the Philips RC-5 communication protocol and
can be used with other MOON components.
The ‘FRM-2’ remote uses three AAA batteries (included). To install them, use the
supplied Allen key to remove the three screws located on the back plate; insert the
batteries in the correct direction and then screw the back plate back into place.
The POWER button located on the upper left will switch the integrated amplifier to either
‘Stand by’ or ‘On’ mode.
The INPUT button performs in exactly the same way as the ‘Input’ button
located on the i
5.3’s front panel, sequentially cascading through each of the
integrated amplifier’s inputs.
The VOL+ and VOL– buttons increase and decrease, respectively, the volume level.
The  and  buttons control channel balance; Pressing the left arrow button causes a
decrease in the volume level of the right channel; pressing the right arrow button causes
a decrease in the volume level of the right channel.
The MUTE button, located in the middle of the volume and balance buttons, performs
the identical function as the ‘Mute’ button located on the i
5.3’s front panel.
Figure 3: FRM-2 Remote Control
____________________________________________________________________________________
Remote Control Operation 11