Users Manual Part 1

ENGLISH
7
Charge the Tablet
The Tablet comes with a built-in rechargeable lithium-polymer battery. It is recommended to fully charge
the battery before first use.
To charge the Tablet, plug the charger to an electrical socket with the other end of the adapter
inserted to the microUSB input slot on the Tablet (Refer to Step 1 on the previous page).
You may continue to use the Tablet while it is charging. You may stop charging any time even
when it is not 100% charged.
If the Tablet is powered on, the battery charge status will be
indicated at the top right corner of the screen by the battery
meter. If the Tablet is powered off, it will charge until the
battery is full.
When the battery life runs out, the battery meter turns red and the device needs to be charged
soon. It will continue to operate as usual until it drops to 0%.
Disconnect the power adapter when the Tablet is fully charged.
Note: When the Tablet is connected to a computer via the USB cable, the battery will charge via the USB
socket, but at a much slower rate than the power adapter supplied.
Do not use any other power adapters than the one supplied. Using an incompatible power adapter
could damage the tablet and poses the potential risk of fire.
Turn on the Tablet
Press the power key circled in red for 5 seconds.
Wait for about 30 seconds for Android to load and start.
The Tablet will guide you through the basic setup.
Initial setup
On the welcome page, scroll to select the desired language.
Tap the arrow circled in green to proceed.
Select a Wi-Fi network, i.e. the wireless network for Internet connection
Enter the password and wait for the connection and system check. It may take up to 2 minutes.
Sign in to your Google account
If you have an existing Google account
Enter your Google email and press Next
Enter your Google account password and press Next
Accept the Terms of Service and Privacy Policy
If you do not have a Google account yet
Select “Or create a new account”
Enter you first name and last name and press Next