User Manual

P/N R64216 v3.1 Page | 10
QUICKSTART GUIDE
In order to ensure successful operation of the SRS, the following steps must be completed:
Before Field Use
1. Install MxEncoders in each player’s helmet using supplied Velcro.
NOTE: See the Equipment Guide for help on MxEncoder installation and the MxEncoder/Helmet
compatibility chart.
2. Install charged battery pack into each MxEncoder.
3. Install the overliner if the helmet is supplied with one.
4. Edit/verify that all player profiles have the correct MxEncoder serial number and helmet model/size.
On the field
1. Setup Field Case in a central location of the sideline and away from large metal objects.
2. Plug in power cable to side of Field Case and then into power outlet/extension cord.
3. Attach Sideline Controller Mast to side of Field Case.
4. Screw Sideline Controller onto Mast.
5. Attach Antenna to Sideline Controller connector.
6. Adjust Mast height so Sideline Controller is ~5’ off the ground.
7. Plug Sideline Controller USB Cable into side of Field Case.
8. Start SRS Computer and start the HIT Analyzer program.
9. Enter your Session or create a new session within the Session Manager.
10. Begin collecting data by entering session.
End of session
1. Close out of SRS Software and shutdown the computer.
2. Unplug Sideline Controller, unscrew Antenna, unscrew from Mast, and store components back in Field
Case.
3. Unplug power cable and store in Field Case.
4. Close Field Case.