User Manual

P/N R64216 v3.1 Page | 11
EQUIPMENT GUIDE
MxEncoder
Installation
To install Revolution IQ and Revolution Speed MxEncoders in a helmet:
1. Separate the Velcro strips attached to the back of the MxEncoder.
2. Remove the adhesive backings from the loop side.
3. Adhere to corresponding location on the inside of the helmet (Figure 15)
Figure 15: Position of MxEncoder Velcro strips inside of helmet.
4. Position the MxEncoder in the helmet as shown in Figure 16.
Figure 16: Initial position of the MxEncoder prior to inserting it fully.
5. Press the center of the MxEncoder firmly down into the gap between helmet pads.