User Manual

P/N R64216 v3.1 Page | 14
Field Case
Sideline Controller
(Only applicable to 900MHz only and Dual Mode Field Case models) The SRS
Sideline Controller should be stored in the Field Case when not in use. The Sideline
Controller is water resistant and can remain in use during inclement weather.
To use the Sideline Controller follow the steps below:
1. Screw the bottom of Sideline Controller onto the Sideline Controller Mast.
2. Screw the Antenna onto the top of the Sideline Controller.
3. Plug in the waterproof USB cable to the side of the Field Case.
4. Screw on waterproof connector.
5. Adjust the height of the Mast so the Sideline Controller is ~5 ft. from the ground.
6. Verify the Sideline Controller is working by seeing players turn active on the SRS Software
7. A green indicator light is also visible on the underside of the Sideline Controller when the unit is
working correctly.
Note: Sideline Controllers may experience interference in communication if placed next to large metal objects.
If the Sideline Controller is not working, follow the Troubleshooting Guide (Page 47). There are no serviceable
parts on the Sideline Controller.
Access Point
(Only applicable to WiFi only and Dual Mode Field Case models) The SRS Access
Point should be stored in the Field Case when not in use. The Access Point is water
resistant and can remain in use during inclement weather.
To use the Access Point follow the steps below:
1. Secure Access Point to mast with push pin.
2. Screw the two antennas onto the top of the Access Point.
3. Plug in the waterproof ethernet cable to the side of the Field Case.
4. Adjust the height of the Mast so the Access Point is ~5 ft. from the ground.
5. Verify the Access Point is working by seeing players turn active on the SRS Software
6. The array of green/orange/red lights on the front face of the Access Point are active when the unit is
working correctly.
Note: Access Points may experience interference in communication if placed next to large metal objects.
If the Access Point is not working, follow the Troubleshooting Guide (Page 47). There are no serviceable parts on
the Access Point.
SRS Computer
The SRS Computer comes pre-loaded with all of the software necessary to use the SRS. Verify all connections
on the back of the SRS computer are securely plugged in (AC power adaptor and USB) before use. Turn on the
computer and after the standard Windows startup, you will see your computer desktop with shortcuts for the
SRS software applications.
Figure 21: Sideline Controller.
Figure 22: Access Point (need
picture).