User Manual

P/N R64216 v3.1 Page | 16
Figure 23: SRS Field Case cabling diagram
Battery Charger
Use
The SRS Battery Charger is capable of charging 40 MxEncoder Battery Packs simultaneously. To use the
Battery Charger, follow these steps:
1. Plug in the power cable to the side of the Charger and then into a 120V AC power outlet.
2. Confirm that all charger lights turn green momentarily then turn to red (this is a self-test).
3. Plug in MxEncoder Battery Packs into each of the charging ports.
4. Once a Battery Pack is fully charged, its corresponding light will turn green.
NOTE: Typical charging time is 4-6 hours for a full charge.
IMPORTANT: Do not close the charger lid while in use. Battery Charger should only be used indoors in a
well-ventilated area. Only charge Riddell SRS MxEncoder Battery Packs using the SRS Battery Charger.
Service
The SRS Battery Charger has no serviceable parts. If one or more of the charging lights becomes damaged,
see the Troubleshooting Guide (Page 47) to arrange for repair.
SOFTWARE GUIDE
Note: The Riddell SRS Software has been pre-loaded and customized for your specific team. There are no
user adjustments/settings to any of the pre-loaded applications. Removal or installation of additional