User Manual

P/N R64216 v3.1 Page | 35
Monitoring Head Impact Exposure (HIT Analyzer Only)
When you have a session defined and players assigned MxEncoders, you are ready to start collecting impact
data. The following sections describe the process of collecting and viewing data and the viewing options
available.
Data Collection Overview
Figure 37: HIT Analyzer data collection screen prior to downloading any impact data.
The following steps outline the process of collecting impact data using HIT Analyzer.
1. Start the HIT Analyzer program and enter your session by clicking on the “Enter Session” button in the
upper right hand corner of the screen. If this button is inoperable, check your session list to verify that
you have a session defined for that time. Once you enter the session you will be presented with a screen
similar to the one shown in Figure 37.
NOTE: You can enter a session before the start of the session. If you enter a session prior to the start
time, your SRS laptop will download and store the data but it will not be considered valid session data.
To include this data in your session at a later point in time, use the RedZone application (see section
6.4.1).
Check the message in the bottom left hand side of the screen.
The message should say “Scanning Players”. This means that the Sideline Controller and/or Access
Point is/are active and trying to communicate with MxEncoders in the field.
NOTE: If you get a persistent error message, unplug the Sideline Controller and/or Access Point from
the field case and then reconnect it. If you continue to get an error message refer to the Troubleshooting
section of this manual.
2. Verify that the players are communicating with the system (Sideline Controller and/or Access Point).