User Manual

PRELIMINARY COPY Page 10 of 19 P/N 02-81011 v 2.2
PRE-GAME SETUP
Configuration and setup of the HIT System is easily completed in about 10 minutes prior
to the beginning of play each day. Setup may be completed by accomplishing the
following steps:
HIT System Setup
1. Remove the Sideline Receiver and Sideline Receiver Stand from the Field Case.
2. Unlock the clamps on the Sideline Receiver Stand, fully extend the telescoping
stand legs, and lock the clamps in place.
3. Slide the keyhole plate on the bottom of the Sideline Receiver Stand over the
posts on the left side of the Field Case and lock in place.
4. Screw the Sideline Receiver onto top of Sideline Receiver Stand. Adjust height
so that the base of Sideline Unit is approximately 5 feet above the ground.
5. Connect the Sideline Receiver Cable to the Data Port on the outside of the Field
Case.
6. Connect the Field Case to a 120V source.
Important: The HIT System Computer and Sideline Receiver will operate for ~3 hours
on the computer battery if fully charged. The Alert Pager will not operate unless
the field case is connected to a 120V source on the field. For best results, it is
recommended to have a 120V source connected to the HIT System at all times during
use.
Software Initialization
1. Turn on the computer by pressing the power button located centrally above the
keyboard.
2. Login to the HITS User Profile: Click on HIT System → (Leave the Password field
blank) → Enter.
3. Run the HITS™ Software by clicking on the HITS™ Software icon either on the
desktop or in the Start → Programs → Head Impact Telemetry System.
Deleted: 0