User Manual

PRELIMINARY COPY Page 2 of 19 P/N 02-81011 v 2.2
FCC Compliance Regulatory Statements
These FCC statements apply to SIDELINE RECEIVER and MxENCODER:
Compliance Statement ( Part 15.19 )
The SIDELINE RECEIVER and MxENCODER devices comply with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. These devices may not cause harmful interference, and
2. These devices must accept any interference received, including interference that may
cause undesired operation.
Warning ( Part 15.21 )
Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
SIDELINE RECEIVER
RF Exposure ( OET Bulletin 65 )
To comply with FCC’s RF exposure limits for general population / uncontrolled exposure, the
antenna(s) used for this transmitter must be installed to provide a separation distance of at least
20 cm from all persons and must not be co-located or operating in conjunction with any other
antenna or transmitter.
MxENCODER
This device and its antenna has shown compliance with FCC’s SAR limits for general population /
uncontrolled exposure for a portable device. The maximum listed SAR level is 1.27 W/kg (head).
The antenna used for this device must not be co-located or operating in conjunction with any
other antenna or transmitter.
Industry Canada Statement
The term “IC” before the certification/registration number only signifies that the Industry Canada
technical specifications were met.
SIDELINE RECEIVER
Section 5.5 of RSS-210
This device has been designed to operate with an antenna having a maximum gain of 5 dBi using
an omni directional antenna. Antenna having a higher gain is strictly prohibited per regulations
of Industry Canada. The required antenna impedance is 50 ohms.
Section 5.11 of RSS-210
To reduce potential radio interference to other users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated power (EIRP) is not more than that required for
successful communication.
MxENCODER
Section 14 of RSS-210
The installer of this radio equipment must ensure that the antenna is located or pointed such that
it does not emit RF field in excess of Health Canada limits for the general population.
Consult Safety Code 6, obtainable from Health Canada’s website: www.hc-sc.gc.ca/rpb
.
Deleted: and 8 dBi if a directional
patch antenna is used
Deleted: 0