User's Guide

P/N R63314 v1.08c
Page | 11
SETUP SUMMARY
In order to ensure successful setup, the following steps must be
complete:
1) Install and charge Alert Monitor batteries (see Battery Care, p.19).
Install Player Units in helmets as required and complete InSite
Player Setup Form for subsequent use when configuring InSite
software (see Installation into Helmets, p.23).
Note: Player Units may be supplied pre-installed in the helmet.
2) Install InSite Player Management software on your computer.
Administrator-level access rights are required for installation (see
Software Guide – InSite Player Management, p32).
3) Configure InSite using InSite Player Management software (see
Software Guide – InSite Player Management, p32).
a) Register and accept Terms and Conditions of use
b) Add Alert Monitor(s) (see Alert Monitor Setup, p.33)
c) Add Player Units (see Player Unit Setup, p.35)
d) Assign Player Units to Players (see Player Setup, p.38)
4) Synchronize Alert Monitor(s) with InSite Player Management
software.
Synchronization transfers setup programming to the Alert
Monitor from InSite Player Management software. (see Player
Setup, p.38)
5) Check in All Player Unit(s) with Alert Monitor. Check-ins transfer
setup programming to Player Units from the Alert Monitor(s) (see
Check In Player Units, p.51).