User's Guide

P/N R63314 v1.08c
Page | 28
d) Return the left side pad and left jaw pad to the installed
position.
e) Make sure the Player Unit case is positioned in the recess
between the left and crown pads inside the helmet.
f) Repeat steps 3)d) and 3)e) above for the right side pad and
right S- pad.
g) At this point the InSite Overliner and Player Unit are fully
installed in the helmet. Fine tuning of final positioning should
be performed to ensure all pads and InSite Overliners are
properly positioned. With final positioning completed, tuck in
the Overliner neck tabs at the rear of the helmet and secure to
the hook and loop fasteners on the back side of the helmet
liner back pad.