User's Manual

Smart Machine Smart Decision
SIM7600SA-H_User Manual_V1.00 2017-10-11
3.2 Power on/Power off/Reset Function
3.2.1 Power on
SIM7600SA-H can be powered on by pulling the PWRKEY pin down to ground.
The PWRKEY pin has been pulled up with a diode to 1.8V internally, so it does not need to be
pulled up externally. It is strongly recommended to put a100nF capacitor, an ESD protection diode,
close to the PWRKEY pin as it would strongly enhance the ESD performance of PWRKEY pin.
Please refer to the following figure for the recommended reference circuit.
4.7K
47K
Turn on / off
impulse
PWRKEY
Power
On / off logic
1.8V
MODULE
100Ω
100nF
The high voltage of PWRKEY is 0.8V
Figure 9: Reference power on/off circuit
Note: Module could be automatically power on by connecting PWRKEY pin to ground via 0R
resistor directly.
The power-on scenarios are illustrated in the following figure.
STATUS
(Output)
T
on
VBAT
PWRKEY
(Input)
T
on(status)
UART Port
Undefined
Active
T
on(uart)
Undefined
Active
USB Port T
on(usb)
Figure 10: Power on timing sequence