User's Manual

Smart Machine Smart Decision
SIM7600SA-H_User Manual_V1.00 2017-10-11
R4
C3
MODULE
59
AUX_ANT
GND
C4
58
R3
Matching circuit
Diversity antenna
D2
Figure 31: Antenna matching circuit (AUX_ANT)
In above figure, R3, C3, C4 and R4 are used for auxiliary antenna matching. By default, the R3, R4
are 0Ω resistors, and the C3, C4 are reserved for tuning. D2 is a TVS for ESD protection, and it is
optional for users according to application environment.
Two TVS are recommended in the table below.
Table 28: Recommended TVS
Package
Part Number
Vender
0201
LXES03AAA1-154
Murata
0402
LXES15AAA1-153
Murata
Note ： SIMCom suggests the LTE auxiliary antenna to be kept on, since there are many high
bands in the designing of TDD-LTE. Because of the high insert loss of the RF cable and layout
lines, the receiver sensitivity of these bands above will have risk to meet the authentication
without the diversity antenna. For more details about auxiliary antenna design notice, please
refer to document [25].
4.3 GNSS
SIM7600SA-H merges GNSS (GPS/GLONASS) satellite and network information to provide a
high-availability solution that offers industry-leading accuracy and performance. This solution
performs well, even in very challenging environmental conditions where conventional GNSS
receivers fail, and provides a platform to enable wireless operators to address both location-based
services and emergency mandates.
4.3.1 GNSS Technical specification
 Tracking sensitivity: -159 dBm（GPS）/-158 dBm（GLONASS）
 Cold-start sensitivity: -148 dBm
 Accuracy (Open Sky): 2.5m (CEP50)
 TTFF (Open Sky) : Hot start <1s, Cold start<35s