User's Manual

1.6Antennas:
The module does not have a standard antenna.
1.7Label and compliance information
This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this
devicedoes not cause harmful interference.AnyChangesor modificationsnot expressly approved by
the party responsible for compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
againstharmfulinterferenceinaresidentialinstallation.Thisequipmentgeneratesusesandcanradiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmfulinterference to radio communications. However, thereis noguarantee thatinterference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
Body-worn Operation
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated withmini mum distance 20cm between
the radiator & your body The host product Labeling Requirements:
NOTICE: The host product must make sure that FCC labeling requirements are met. This includes
clearly visible exterior label on the outside of the final product housing that displays the contents
shown
in below:
Contains FCC ID:2AJYU-8PYA002
1.8Information on test modes and additional testing requirements:
When setting up the configuration, if the pairing and call box options for testing do not work, the
tester
needs to coordinate with the module manufacturer to access the test mode software.
1.9Additional testing, Part 15 Subpart B disclaimer:
The modular transmitter is only FCC authorized for the specific rule parts (FCC Part 22,24,27) list
on the grant, and that the host product manufacturer is responsible for compliance to any other FCC
rules that apply to the host not covered by the modular transmitter grant of certification.
1.10Information on test modes and additional testingrequirements:
When testing, testers need to refer to the user manual, and the sample power supply needs to use a
specialadapterpowersupply