User's Manual
Table Of Contents
- Version History
- Contents
- Table Index
- Figure Index
- 1Introduction
- 2 Package Information
- 3 Interface Application
- 4 RF Specifications
- 5 Electrical Specification
- 6 SMT Production Guide
- 7 Packaging
- 8 Appendix
SIM7600G-H User manual
www.simcom.com
3
/
75
For a host manufacture’s using a certified modular, if (1) the module’s IC number is not visible when
installed in the host, or (2) if the host is marketed so that end users do not have straightforward
commonly used methods for access to remove the module so that the IC number of the module is
visible; then an additional permanent label referring to the enclosed module: “Contains Transmitter
Module IC: 23761-8PYA008” or “Contains IC: 23761-8PYA008” must be used.
This radio transmitter IC: 23761-8PYA008 has been approved by Imovation,Science and Economic
Development Canada to operate with the antenna types listed below,with the maximm permissible gain
indicated.Antenna types not included in this list that have gain greater than the maximm gain indicated for
any type listed are strictly prohibilted for use with this device.
Antenna List:
Type: Dipole antenna with non-standard SMA connector(50ohm);
Model: MF25D
Antenna Gain:
Band 2:1.87dBi, Band 4:3.12dBi, Band 5:0.91dBi, Band 12:0.95dBi,
Band13:2.23dBi, Band 25:1.87dBi, Band 26:0.91dBi, Band 41:2.9dBi,
Band 66:3.12dBi
Single Module
Declaration of Conformity
SIMCom Wireless Solutions Limited, hereby declares that this LTE /HSPA/GSM/GNSS MODULE in
compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU.
In accordance with Article 10(2) and Article 10(10),This product is allowed to be used in all EU member
states.
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept
any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
The modular can be installed or integrated in mobile or fix devices only. This modular cannot be
installed in any portable device.
FCC Radiation Exposure Statement
This modular complies with FCC RF radiation exposure limits set forth for an uncontrolled