SDS

Page 4/10
Safety Data Sheet (SDS)
OSHA Hazard Communication Standard 29 CFR 1910.1200. Prepared to GHS
Rev03.
Reviewed on 3/14/19
Trade name: ROKREZ BASE
(Contd. of page 3)
37.1.18
·
Conditions for safe storage, including any incompatibilities
·
Storage:
·
Requirements to be met by storerooms and receptacles:
No special requirements.
·
Information about storage in one common storage facility:
Not required.
·
Further information about storage conditions:
Keep receptacle tightly sealed.
·
Specific end use(s)
No further relevant information available.
8 Exposure controls/personal protection
·
Additional information about design of technical systems:
No further data; see section 7.
·
Control parameters
·
Components with limit values that require monitoring at the workplace:
The product does not contain any relevant quantities of materials with critical values that have to be monitored
at the workplace.
·
Additional information:
The lists that were valid during the creation were used as basis.
·
Exposure controls
·
Personal protective equipment:
·
General protective and hygienic measures:
Keep away from foodstuffs, beverages and feed.
Immediately remove all soiled and contaminated clothing.
Wash hands before breaks and at the end of work.
Avoid contact with the eyes and skin.
·
Breathing equipment:
In
case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure,
use respiratory protective device that is independent of circulating air.
·
Protection of hands:
Protective gloves
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/
the chemical mixture.
Select glove material based on penetration times, rates of diffusion and degradation.
·
Material of gloves
The selection of the suitable gloves does not only depend on the material, but also on further marks of quality
and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the
resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the
application.
·
Penetration time of glove material
The exact break-through time has to be determined and observed by the manufacturer of the protective
gloves.
·
Eye protection:
Tightly sealed goggles
*
9 Physical and chemical properties
·
Information on basic physical and chemical properties
·
General Information
·
Appearance:
Form:
Color:
Liquid
Gray,Dark Gray, Tan
(Contd. on page 5)