DA200S Amplifier user’s Manual www.simmonsdrums.
FCC Statements 1. Caution: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. 2. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
DA200S important safety instructions Exposure to high noise levels may cause permanent hearing loss. Individuals vary considerably to noise-induced hearing loss but nearly everyone will lose some hearing if exposed to sufficiently intense noise over time. The U.S.
DRUM Amplifier Table of Contents 2 Important Safety Instructions 1 Welcome and Congratulations 3 Features 4 Front Panel 5 Back Panel 6 Specifications 7 DA200S Signal Flow Diagram 8 DA200S DRUM AMPLIFIER User’s Manual
DA200S welcome and Congratulations! … on your purchase of the Simmons DA200S Electronic Drum Amplifier. To get the most enjoyment, we recommend that you review this manual at least once, then refer back to it often to learn more about specific functions. Taking Care of Your Digital Drum Amplifier Location • To avoid deformation, discoloration, or more serious damage, do not expose the unit to direct sunlight, high temperature sources, or excessive humidity.
DRUM Amplifier features 1 2 3 4 A Note on Stereo Imaging 5 6 7 The Simmons DA200S is a true stereo drum amplifier. It will maintain the integrity of the stereo drum signal from input to speakers (including Line Outs and Extension Speaker Jacks). This provides a broad stereo field that positions your drums at their correct sonic locations, providing a realistic audio experience for you and your audience.
DA200S front panel 5 ¼ 1 2 3 4 6 7 1 Drum Inputs: These are 1/4” input jacks (left and 2 right). When using a mono signal, plug into the Left/Mono Jack. Aux Input: This 1/4” stereo jack is used for connecting any pre-EQ source such as a click track, additional digital instruments, devices, drum pad MPC machines, etc. The volume of the Aux Input is controlled by the Aux Volume control. 3 Drum Volume: This controls the volume level of the Drum Inputs to the power amplifier.
DRUM Amplifier back panel 1 3 2 4 1 Left and Right Line Outs: These balanced 3 Ground Lift: Use this switch to eliminate hum or 2 Volume Control for Line Outs: This control 4 Extension Speakers Jacks: The DA200S XLR Line Outs provide quiet, noise-free signal flow through a standard mic cable or snake to a recording or live console. is completely independent from the Master volume on the front panel, allowing you to set your feed level to a mixing console.
DA200S specifications Model DA200S Electronic Drum Amp Output Power (RMS 1% ) 50 Watts @ 8 Ohms (x2) Tweeter Internal Speakers (Stereo) 50 Watts @ 4 Ohms (x2) Midrange Internal Speakers (Stereo) 100 Watts @ 8 Ohms (x1) Subwoofer Internal Speaker (Mono) 500 mWatts @ 32 Ohms (x2) Output to Headphones (Stereo) Frequency Response 20 Hz - 20 kHz Tailored for accurate acoustic response for electronic drums Hum and Noise -60 dBV All controls turned down -55 dBV All controls turned halfway
DRUM Amplifier DA200S Signal flow diagram 8 User’s Manual
Three (3) Year Limited Warranty Subject to the limitations set forth below, Simmons® hereby represents and warrants that the components of this product shall be free from defects in workmanship and materials, including implied warranties of merchantability or fitness for a particular purpose, subject to normal use and service, for three (3) years to the original owner from the date of purchase.
www.simmonsdrums.